Water Tech Pool Blaster Pulse - Getting Started; Set Up for Battery Charging

 chemicals. Never leave the cleaner plugged for long term storage. Recharge the cleane
r
every three months.
A
bove warnings and cautions are not intended to incorporate all possible instances fo
r
r
isks and / or severe injury. Pool / spa owners should always exercise intensive caution an
d
c
ommon sense when utilizing the cleaner.
G
ETTING STARTED
S
et Up for Battery Charging
W
ARNING!

Charging must be done indoors, in a well-ventilated area away from the sunlight, children,
heat and ignition sources.

Never use the external adaptor and charging base if any damage is found.

Use the original external adaptor provided only.

Make sure cleaner and Charging Base are clean and dry before set up.
T
here are two different ways of setting up the cleaner ready for battery charging.
F
ree Standing
1
. Place your cleaner on a dry, clean and flat surface with Contact Plate on the cleaner facin
g
u
pwards.
2
. Slide the Charging Base wider hook inside the Hanging Slot on the cleaner handle. Press th
e
o
ther end of Charging Base down into the gap (between the Filter Cone base and rear body) unti
l
t
wo extended hooks are secured under the tabs on the Filter Cone base. Fig. 1