Water Tech Pool Blaster Pulse - Charging the Battery

W
all Mounted
1
. Use screws (not included) to fix the Charging Base to the wall at a height at least 16 inche
s
(
40cm) above a level surface. Fig.2
2
. Align Hanging Slot of the cleaner to the upper hook of the Charging Base. Push the cleaner t
o
C
harging Base until two extended hooks are secured under the tabs on the Filter Cone base
.
F
ig.3
C
harging the Battery
W
ARNING!

DO NOT handle the cleaner, external adaptor and charging base while charging with wet hand
s
and without shoes.

Connect the external adaptor to power source through a residential current device (RCD).

Charge the cleaner with the original external adaptor provided.

DO NOT use power extension cords.
C
harge and Recharge time:
C
harge the cleaner 4 hours prior to the first use. Re-charge time is 4 hours.
1
. Plug the female jack of the external adaptor into the charging port on the side of Chargin
g
B
ase.
2
. Connect the external adaptor to the power source. Now the indicator light on the external
a
daptor shows red color. Normally, it takes about 4 hours to complete charging and indicator
l
ight turns to green color.