Water Tech Pool Blaster Pulse - Starting and Stopping Pump Motor; Emptying the Filter; Filter Cleaning Procedure


DO NOT use this cleaner to pick up any toxic substance, flammable or combustible liquids suc
h
as gasoline, or operate in the presence of explosive or flammable fumes.
C
AUTION

Use original accessories delivered with this product.

DO NOT leave the cleaner in the water when not in use or when battery is low as water leakag
e
may occur.
S
tarting pump motor
1. Bring your cleaner to the side of your pool / spa. Press the On/Off button to start pum
p
motor, immediately immerse the cleaner into water after the pump motor is operating.
S
topping the pump motor
2. Remove the cleaner from the pool / spa. Lift cleaner out of water, keep it face downwar
d
to allow water to escape from the Outlet Valve and Handle / Pole Connector.
3. Turn Off pump motor. Press On/Off switch to turn off pump motor.
C
AUTION! When removing the cleaner from the pool with telescopic pole, always keep th
e
c
leaner facing downward. Otherwise it may bend the Pole Connector and damage it.
It is recommended to rinse the cleaner and filter with fresh water after every use.
E
MPTYING THE FILTER
F
or maximizing the cleaning efficiency, always clean the filter before and after use.
C
AUTION

Always disconnect the external adaptor from power source and detach the cleaner from th
e
Charging Base before performing any routine cleaning or maintenance of cleaner.
1
. Place the cleaner on a stable surface.
2
. Press down the Filter Sleeve Locking Tab; rotate the sleeve until its tabs are released from th
e
slots on the Filter Cone Base. Fig. 7