WaterLogic WL100 User Manual (English)

Other manuals for WaterLogic WL100

Manual69 pages

User Guide10 pages

Technical Manual16 pages

Installation Procedures10 pages

Troubleshooting13 pages

Questions and Answers:

S
smcmillanAug 1, 2025
Why is my WaterLogic Water Dispenser compressor running but not chilling?
- L
  Luke HendersonAug 1, 2025
  If the compressor on your WaterLogic Water Dispenser runs but doesn't chill, the condenser might be dirty. Clean the condensing coil to remove any obstructions or dust. Insufficient airflow into the unit could also be the problem, so ensure there are at least 2 to 4 inches of space around it for ventilation. If the compressor is running very hot, it may indicate low or lost refrigerant, requiring a refrigerant recharge.
S
Stacy MillsAug 5, 2025
Why is the cold water not cold enough in my WaterLogic Water Dispenser?
- S
  Sharon WilsonAug 6, 2025
  If the cold water from your WaterLogic Water Dispenser isn't cold enough, ensure the red heater and compressor switch is turned on. If the tank has run out of cold water, wait for it to chill. Check the cold water thermostat with a multimeter and replace it if required. If the refrigerant has run out, run the compressor for at least ten minutes; if the condenser is not warm, refill the refrigerant. If the compressor has a problem, repair or replacement is needed.
V
Veronica PerryAug 10, 2025
What to do if the red heater and compressor power switch won't light on my WaterLogic Water Dispenser?
- A
  Amy PenaAug 10, 2025
  If the red heater and compressor power switch on your WaterLogic Water Dispenser won't light and the red LED on the front isn't lit, check the circuit breaker. Also, verify that the power cord is properly plugged in, and try a different power cord to rule out any defects. The fuse might be blown, so replace it if necessary. A failed power line noise filter (EMI) or a defective red heater/compressor switch could also be the cause, so consider replacing those components.
M
Matthew MurphyAug 16, 2025
How to fix hot water that is not hot enough in my WaterLogic Water Dispenser?
- M
  mario13Aug 16, 2025
  If the hot water from your WaterLogic Water Dispenser isn't hot enough, first check that the red heater and compressor switch is turned on. If no water has been dispensed for 3 or more hours, the unit goes into sleep mode. Dispense hot water and wait 5 minutes to check the temperature. If the unit still doesn't heat, there may be no power to the heater elements. Also, the hot tank overload might have tripped, so push to reset it. Inspect the Energy Saver PCB relay board connector for discoloration. If there is no discoloration, contact Waterlogic Technical Department. Check the thermostat or overload, look for loose or improperly connected wires, and check the heating coil. Finally, verify that the jumper pins are correctly located for the hot water option.