To Next Page
P
Penny JohnsonJul 31, 2025
What to do if my WaterLogic WL500 – Sparkling Water Dispenser displays 'No Water Supply'?
- AAmanda DuffyJul 31, 2025
If your WaterLogic Water Dispenser displays 'No Water Supply', here are several potential causes and solutions: * The water supply may be shut off. Ensure water is available to the unit and the Filter Timer is active instead of the Filter Counter. * The filters may be clogged. Try changing the filters. * The CO2 gas pressure might be too high (above 45 psi), preventing the sparkling chamber from filling. * The Level Sensor may be dirty. Remove and clean the probe after disconnecting from power, shutting off CO2 gas, and relieving pressure in the tank. * The Filter Counter may be enabled without a signal. Enable the Filter Timer.
General
