Need help?Do you have a question about the WaterLogic WL Cube Firewall and is the answer not in the manual?
General| Model | WL Cube Firewall |
|---|---|
| Cooling System | Compressor |
| Heating System | Instant Heating |
| Power Consumption | 500W |
| Voltage | 220-240V |
| Frequency | 50/60 Hz |
| Certification | CE, RoHS |
| Type | Water Dispenser |
| Water Types | Hot |
| Capacity | 3.0 Liters |
| Cold Water Temperature | 5°C |
Describes the availability options for the WL Cube water dispenser.
Details the cold water tank specifications, material, capacity, and default temperature setting.
Explains the hot water tank features, temperature control, safety cut-out, and capacity.
Outlines the function of filtration systems for reducing dirt, sediment, and contaminants.
Describes the Firewall chamber housing the in-faucet UV system, lamp, and quartz spiral.
Details the in-faucet UV sterilization system, its function, and available sensors.
Illustrates the water flow path for cold, hot, and ambient water within the WL Cube.
Warns about handling heavy units and potential trip hazards from packing materials during PDI.
Warns about mounting, ventilation, proximity to heat sources, and ambient temperature limits.
Lists parts and requirements for the recommended Waterlogic installation kit, including pressure settings.
Explains the automatic sleep mode and power saving functionality of the WL Cube.
Provides steps for dispensing cold, ambient, hot, and extra hot water using the dispense button.
Highlights safety precautions when dispensing hot water, including cup placement and avoiding stop-start vending.
Advises on recommended service intervals, including UV lamp and filter changes.
Lists the tools and parts needed for performing maintenance procedures on the WL Cube.
Details the step-by-step procedure for sanitizing the water dispenser using sanitisation fluid.
Lists the tools and materials needed for performing the sanitisation procedure.
Lists the tools and materials needed for performing the de-scaling process on the WL Cube.
Explains icons for hot water, dispensing, cold water, and ambient water selection.
Explains icons indicating UV lamp status, power, filter demand, and leak detection.
Troubleshooting steps for issues with no water flow, including supply and filter checks.
Troubleshooting for temperature issues, low flow, and frozen cold tanks.
Advice for resolving unusual water taste and troubleshooting water leaks.
Troubleshooting steps for power loss, fuse checks, and system alarms.
General safety warnings and conditions that invalidate product warranties.
Presents detailed technical specifications for the 120V and 230V WL Cube models.
Disposal guidelines for Non-EU countries and EU WEEE directive compliance.
Information on ROHS compliance and BioCote® antimicrobial technology and FAQs.
Warning about high voltages present on the PCB in the 120V electrical wiring diagram.
Warning about high voltages present on the PCB in the 230V electrical wiring diagram.
Identifies the main PCB and shows dip switches 1 & 2 with instructions for basic setup.
Details settings for UV sensor, filter timer intervals, and cold/hot water temperatures.
Details the setting for the sleep mode feature on the WL Cube.
Lists and illustrates the wetted parts for the hot, cold, and ambient water circuits.
Lists additional wetted parts and connectors used in the sparkling water circuit.
Provides an illustration identifying the main external and internal parts of the WL Cube.
Lists further parts and components of the WL Cube, including electronics and housings.
To Next Page