Need help?Do you have a question about the WaterLogic WL Cube and is the answer not in the manual?
General| Type | Point-of-Use Water Dispenser |
|---|---|
| Filtration Technology | Multi-stage filtration |
| UV Sanitization | Yes |
| Cooling Method | Compressor |
| Water Types | Cold, Ambient, Hot |
| Power Supply | AC 220V/50Hz |
| Water Connection | 3/8" |
| Certifications | CE, RoHS |
| Heating Capacity | 5 L/h |
Covers critical safety measures for operating, installing, and maintaining the CUBE unit.
Outlines necessary materials and initial steps before installing the CUBE.
Detailed steps for sanitizing the CUBE water system.
Procedures for safely draining the hot and cold water tanks and system.
Covers safety, local codes, electrical, water supply, and environmental requirements for installation.
Step-by-step instructions for replacing the filter cartridge.
Detailed steps for removing and installing a new UV lamp.
Guide for removing mineral deposits and scale from the hot water tank.
Describes the fault code for an overheat condition and its solution.
Explains the UV purification fault and the need to replace the UV light.
Details the filter service alert and how to reset the service timer.
Describes the leak detection alarm and troubleshooting steps.
Addresses problems where hot water isn't hot or cold water isn't cold.
To Next Page