REPLACEMENT COMPONENTS
Every 12 months, or as required
WLUSA# NA
Clean every 12 months, replace as
needed
10” 1 Micron Filter Assembly
Every 12 months. Local water
conditions will determine proper filter
type and maintenance schedule.
Replacement parts can be obtained from Waterlogic or an Authorized Waterlogic Dealer.
See Parts Layouts, Drawings, and Lists for additional repair parts.
Hot Tank HT-0001-I00 Service
Hot Tank (with controls) must be replaced at least every 5 years.
Descaling hot tank may be required on a regular basis depending
upon filtration and local water conditions. See Service Section.
NOTE:
At the end of this product’s life, ensure that it is disposed of
in an environmentally friendly manner which is fully compliant
with all Federal/State/Local Requirements and Guidelines.
CUBE Operating, Installation, and Service Manual Page 38 - Revision: 6-23-2015