WaterLogic WL Cube - Page 37

A. Insert the filter assembly back into its cradle,
aligning the two male spigots with the female holes
in the cradle
B. Push it firmly until the filter sits snugly and is flush
with the cradle top surface
C. Lock the filter by closing the locking lever until it
‘clicks’ into place
13.
Replace Top Cover and Screws.
14.
Turn on the Water Supply
15.
Turn on Red Power Switch I=ON
16.
Select Cold Water and dispense until water flows clear. This step flushes the carbon fines
from the filter.
17.
Turn on Green Heater / Compressor Switch. I=ON
CUBE Operating, Installation, and Service Manual Page 37 - Revision: 6-23-2015