Watlow DIN-A-MITE C - Unit Dimensions - Rail-Mounted; Unit Dimensions - Through-Wall (Cabinet Panel)

WATLOW DIN-A-MITE Style C User's Manual
7
ç
Ó
3
WARNING:
Only authorized and
qualified personnel should
be allowed to install and
perform preventive and
corrective maintenance on
this unit. Failure to follow
this guideline could result
in damage to equipment,
and personal injury or
death.
5
WARNING:
Hot surface, do not touch
the heat sink. Failure to
follow this guideline could
result in personal injury.
ç
Mount the cooling fins
vertically.
Unit Dimensions - Rail-Mounted
ç
Ó
3
5
142 mm (5.59 in)
131 mm
(5.17 in)
146 mm (5.74 in)
102 mm (4.0 in)
Front panel is touch-safe, no clearance is required.
102 mm (4.0 in) clearance for air flow and wire bending radius
102 mm (4.0 in) clearance for air flow and wire bending radius
150 mm
(5.89 in)
Rail Release Tab
(pull down)
44 mm
(1.73 in)
57 mm
(2.26 in)
127 mm
(5.00 in)
79 mm
(3.10 in)
102 mm (4.0 in) minimum
Side
Front
138 mm
(5.45 in)
54 mm (2.11 in)
46 mm (1.81 in)
38 mm (1.51 in)
123
456
48 mm
(1.89 in)
Allowance for M4
(#8 Fastener)
Allowance for M4
(#8 Fastener)
DIN-EN 50022
35 by 7.5 mm rail
(clipping distance =
34.7 to 35.3 mm
[1.366 to 1.390 in])
87 mm
(3.42 in)
Ground
wire
entry
146 mm
(5.74 in)
83 mm
(3.25 in)
Top
13 mm
(0.50 in)
Side by side
clearance
for wire routing
Unit Dimensions - Through-Wall (Cabinet Panel)
Top
114 mm
(4.50 in)
57 mm (2.25 in)
outside
(any gauge)
55 mm (2.17 in)
inside
(12 gauge)
Front panel is touch-safe,
no clearance is required.
Sheet Metal (12 gauge)
ç
Ó
3
5
w ww . . co m
information@itm.com1.800.561.8187