30.1 Connecting interface tubing
Note: Please refer to the diagram below in conjunction to the text when connecting
interface tubing to the pumphead.
Before connecting the interface tubing, ensure that the supplied seals* (1) are correctly
fitted in the head ports (1a) and that the seals* and connector material is compatible with
pumped fluid.
*the moulded seals supplied with the pumphead are the same material as the pumphead
tube. ReNu PU pumpheads are supplied with TPU seals, ReNu SEBS pumpheads are supplied
with SEBS seals and ReNu Santoprene pumpheads are supplied with Santoprene seals.
Note: pumpheads manufactured prior to April 2021 will have been supplied with
Santoprene moulded seals only.
Figure 31 - Fit the fluid port seals
m-qdos-allmodels-en-07 143
To Next Page