Do you have a question about the WattMaster CommLink IV and is the answer not in the manual?
Overview of CommLink IV's purpose and functionality.
Details the IP Module Kit for Ethernet and Internet connectivity.
Explains the Remote Link II for dial-up remote communications.
Lists necessary hardware and software for CommLink IV operation.
How to check and set the SW1 DIP switch for communication configuration.
Guide to install USB serial converter drivers for Vista without internet.
Guide to install USB serial port drivers for Vista without internet.
Steps to install USB drivers for Vista using an internet connection.
Steps to install USB serial converter drivers for Windows XP.
Instructions to locate the assigned COM port number in Windows XP Device Manager.
Step-by-step guide to configure Prism software for CommLink IV.
Step-by-step guide to configure Prism II software for CommLink IV.
Describes LOOP, TX-USB, RX-USB, TX-CPU, RX-CPU LEDs.
Describes ACT-LAN and LNK-LAN LEDs for network connectivity.
Discusses configurations needed for Firewall, Proxy, or NAT compatibility.
Lists common issues with Prism software configuration and CommLink IV.
Describes troubleshooting steps for USB connection issues.
Addresses issues related to viewing controllers on the network.
Detailed steps to resolve USB driver installation issues on Vista.
Detailed steps to install or fix USB drivers for Windows XP.
Guide to change USB COM port number if it's 10 or greater.
| Brand | WattMaster |
|---|---|
| Model | CommLink IV |
| Category | Transceiver |
| Language | English |