CommLink IV Technical Guide
14
Operator Interface
Prism II Set Up Instructions
12. Click <Communications> again and select
<Search for Units>.
13. The Search for Installed Units Window will pop up.
Click <Start> to start the search.
14. If everything is working correctly, Units Found on
this Loop should increment.
15. If Units Found on this Loop stays at zero, check the
wiring to the CommLink IV and the AHU/RTU
Controllers and/or read through these directions
again to make sure all steps were followed.
Prism II Set Up
1. Open your Prism II software.
2. Click on the <Login> button and type in
your level 3 passcode (default “9288”).
Click <OK>.
3. If Prism II is online, click the
<ON LINE> button to make it go
<OFFLINE>.
4. Click the <Job-Site> button to open the
Job Sites Window.
5. Click on any empty location in the Job-Site Selection
Window and then type in a job name in the Selected
Location box and press <Enter>.
6. In the Serial Port fi eld, click on the pull down box and
select the COM Port number that the CommLink IV
is using. This port number is the one you should have
found in the Device Manager (XP) or during
installation (Vista).
7. In the Type of CommLink selection box, select the
radio button next to CommLink 4.
To Next Page
Loading...