Thank you for choosing the WATTS WATER QUALITY Reverse Osmosis Drinking Water System. With proper
care your water ltration system will produce high quality drinking water for many years.
Read carefully and follow the instruction in this manual before proceeding with the actual installation. Pay
particular attention to all warnings, cautions and notes. Failure to do so could result in personal injury or
damage to the equipment or other property. System and installation need to comply with state and local laws
and regulations.
CHECK LIST:
1) Reverse Osmosis Unit.
2) Water storage tank, 3 gallon volume (2.5 gallon @40psi).
3) Installation kit: tank ball valve, drain saddle clamp (1/4” & 3/8”), feed water valve, faucet assembly.
4) Manual.
* Variable speed drill
* 1/8” and 1/4” drill bits
* 7/16” drill bit 1/2” and 9/16 open-end wrenches (or adjustable)
* Phillips screwdriver
* Utility knife
RECOMMENDED TOOLS LIST
This reverse osmosis system contains a replaceable component critical to the efciency of the system.
Replacement of the reverse osmosis component should be with one of identical specications, as dened by the
manufacturer, to ensure the same efciency and contaminant reduction performance.
The product water shall be tested periodically to verify that the system is performing
satisfactorily.
Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection
before or after the system.
1) Reverse Osmosis Unit
(525P Shown)
2) Water Storage
Tank 3 Gallon
3) Installation Kit
2
To Next Page
Loading...
Need help?
General
