2.1. Package list
Ensure to check all parts are present:
Liner
Pump Unit
Top Cover
Ground Cloth
3.1. Site selection WARNING: Before proceeding to install your spa, please make sure
that the selected location meets the following conditions:
• A level place in order to avoid any defect, tearing or leakage.
• Wide enough to support the spa and its pump unit.
• Able to support more than 500 kg/m².
• Sheltered from the sun and bad weather.
• Clean and free from sharp objects.
• Devoid of excessive vegetation on the ground.
Failure to comply with these rules may result in property damage or personal injury.
RCD
Air Valve
Inflating Hose
Pump Unit Connectors
Use a sun cover
Place in a clean environment Ensure its level
WARNING: The RCD plug must be tested before each
use... Do not use if RCD test fails and see chapter 6.1.
Caps
Repair Kit
Filter
Cartridge
Filtration Cartridge
Support
1. Insert the plug into the
power outlet.
2. Press the «RESET» button,
the indicator light turns red.
3. Press the «TEST» button,
the indicator light turns off.
4. Press the «RESET» button,
the indicator light turns red.
5. The RCD works properly.
WARNING: If the Spa installed on inadequately level surfaces, they are subject to leaking/ forming irregularities or
collapsing, which can result in property damage or serious injury for those in or around the spa area!
CAUTION: Please choose your set-up area carefully as lawn and other vegetation underneath the ground cloth (if
applicable) will die. Furthermore, try to avoid setting the ground cloth in areas prone to aggressive plant and weed,
growth as they may grow through the ground cloth.
To Next Page
Loading...
