APPENDIX 1. Problem with drivers installation
If you have any problems installing the drivers, they can be installed following
the steps given by Windows when the USB is connected:
1. Connect the USB cord to the PC and the MonitEM-Lab, respectively.
Windows will automatically detect the new device.
(Otherwise, go to Control Panel / System / Hardware / Device Manager,
which should show an incorrectly installed device; right click on that device
and update the driver by clicking right).
2. Do not allow Windows to nd the driver automatically.
3. Select “Install from a list or specic location”.
4. Select D: / Drivers as the location, where "D" is the letter for the USB drive
containing the software.
5. Wait until the driver has been correctly installed. Accept it if warns that it is
not a certied driver.
6. If the driver is correctly installed and the device is connected to a computer,
the list of COM ports will show the port associated with the SMP with the
name "USB Serial Port" (see Start / Control Panel / System / Hardware /
Device Manager / Ports (COM & LTP)).
User’s Manual
Electromagnetic Radiation Monitoring Device MonitEM-Lab P. 20
To Next Page
Loading...
