WaveSense jazz - Page 14

24 25
Meter Ready for Test: The meter now displays the droplet
symbol and the word “Fill”. The WaveSense Jazz System is
now ready for you to apply blood. You do not need to set a
calibration code for this meter.
[3] Lancing: To ensure accurate results, wash hands with
warm, soapy water and dry before every glucose test. For
details on possible test sites, refer to chapter 3.
For instructions on how to test on your palm or forearm,
please refer to chapter 9.
Note: Keep your hand warm or gently
massage the site you are lancing to
stimulate blood flow.
Lance Test Site: Press the lancing
device against the site to be
lanced. Press the release button.
Express Blood Drop: When
testing on a finger tip, wipe away
the first blood drop that appears
using a clean tissue or paper
towel. Squeeze from the base of
your finger up towards the tip,
until a second small blood drop
forms.
Do not squeeze directly around
the lanced area.
If necessary, set the lancing device to a deeper setting or use
a larger lancet to produce enough blood.
[4]
Applying Blood Sample
Bring Test Strip to Blood Sample: The meter now displays
the droplet symbol. This means your WaveSense Jazz System
is now ready for you to apply
blood. Immediately bring the
WaveSense Jazz Test Strip to the
blood sample.
The test strip fills from the tip.
Do not apply blood on the top
surface of the test strip.
The WaveSense Jazz Test Strip
acts like a sponge and draws the
blood into the test strip through
the sample area. The visual fill
window of the WaveSense Jazz
Test Strip will turn red.
This is the visual  ll
window. DO NOT
PUT BLOOD HERE.
Apply blood here.
The entire
visual  ll
window will
turn red.
WARNING: If the visual
 ll window does not
completely  ll, you may
get an inaccurate result.
Retest and ensure that
the visual  ll window is
completely full.
Release
Button