54 55
be included in averages. ACTIONS: If you feel symptoms such
as weakness, sweating, nervousness, headache or confusion,
follow your healthcare professional’s recommendations. If
you get a Lo glucose test result but have no symptoms of low
blood glucose, then retest with a new WaveSense Jazz Test
Strip. If you still get a Lo test result, follow your healthcare
professional’s recommendations.
HI MESSAGE: Flashing message, with double beep (if
volume is ON).
MEANING: Glucose test result is above 600 mg/dL. This Hi re-
sult may indicate hyperglycemia (high blood glucose). The Hi
result is stored in the memory with time and date. It will not
be included in averages. ACTIONS: If you feel symptoms such
as fatigue, thirst, excessive urination, or blurry vision, follow
your healthcare professional’s recommendations. If you get
a Hi glucose test result but have no symptoms of high blood
glucose, then retest with a new WaveSense Jazz Test Strip. If
you still get a Hi glucose test result, follow your healthcare
professional’s recommendations. Checking ketones may be
advisable.
HYPOGLYCEMIC WARNING ALARM: Flashing
message with the time.
Test result flashes, with
double beep (if volume is ON).
MEANING: If the Hypoglycemic Warning Alarm is set, your
glucose test result is lower than the pre-set threshold.
CAUTION: Low or high blood glucose test results can
indicate a potentially serious medical condition. Follow
your healthcare professional’s recommendations.
The ADA (American Diabetes Association) recommends the
following target ranges for adults with Diabetes:
- Pre-Prandial Plasma Glucose: 90-130 mg/dL
- Post-Prandial Plasma Glucose: < 180 mg/dL
Always consult your healthcare professional for your
recommended target ranges.
LO MESSAGE: Flashing message, with double beep
(if volume is enabled).
MEANING: Glucose test result is lower than 20 mg/dL. This Lo
result may indicate hypoglycemia (low blood glucose). The Lo
result is stored in the memory with time and date. It will not
Display Messages
20
CHAPTER
available (located on the test strip vial).
[2] CAUSE: Sample applied after meter times out and
deactivates. ACTION: Repeat the test using a new WaveSense
Jazz Test Strip. Wait until you see the blood and test strip
symbols on the display before you apply the blood sample.
[3] CAUSE: Sample not applied to the tip of the test strip.
ACTION: Repeat the test using a new WaveSense Jazz Test
Strip.
[4] CAUSE: Defective meter. ACTION: Call customer service
and have the meter serial number available (located on the
back of the meter.
To Next Page
Loading...