WaveSense jazz User Manual

6 7
obvious veins and moles.
Physiological differences
in circulation between the
fingertip, palm (at the base of
the thumb), and forearm may
result in differences in blood
glucose test results between
these sites. Differences in
glucose concentrations may be observed after
eating, taking insulin medication, or exercise.
Changes in blood glucose may be detected at
the fingertips before the palm (at the base of
the thumb) and forearm, as there may be a lag-
time in alternate test sites.
It is recommended that you use a  ngertip sample if:
[1]
You are testing for hypoglycemia or if you suffer from
hypoglycemia unawareness,
[2] You are testing your blood glucose within 2 hours of
eating, taking insulin or diabetes pills, exercising, or
[3] Your blood glucose results obtained from the palm (at the
base of the thumb) or forearm are not consistent with the way
you feel.
CAUTION: Please read all the instructions provided in this
Owner’s Guide and practice the testing procedures before
using the WaveSense Jazz Blood Glucose Monitoring
System. Blood glucose monitoring should be done under
the guidance of your healthcare professional.
The WaveSense Jazz System should be used:
[1]
For measuring blood glucose levels from fresh capillary
whole blood samples taken from the fingertip, palms (at the
base of the thumb), or forearms.
[2] With WaveSense Jazz Test Strips and WaveSense Control
Solution only. Use with other unapproved test strips or control
solution will void the manufacturer’s warranty and will lead to
inaccurate results.
[3] Outside of the body (i.e., in vitro diagnostic use only).
Do not use the WaveSense Jazz System for:
[1]
The diagnosis of diabetes.
[2] Testing the glucose levels of neonates.
[3] Testing glucose levels of arterial or venous blood.
Possible test sites:
The WaveSense Jazz System requires only 0.5 μL of blood to
perform a glucose test. For best results, test using blood from
the tip of any finger. The palm (at the base of the thumb) and
forearm are alternate, but less accurate test sites. Only select
soft and fleshy areas to lance. Avoid lancing any bony areas,
Important Information about
Your WaveSense Jazz System
3
CHAPTER

WaveSense jazz Specifications

General

Sample Size	0.5 µL
Test Time	5 seconds
Coding	No Coding Required
Operating Temperature	50-104°F (10-40°C)
Operating Humidity	10-90% RH
Hematocrit Range	30-55%
Measurement Range	20-600 mg/dL
Storage Conditions	36-86°F (2-30°C)