Wavetek 9100 - Page 84

18-10 Model 9100 — Operator's Guide: Error Messages
U
UNDEFINED FATAL ERROR
The firmware detected an unspecified fatal error A
UNEXPECTED case in switch statement A
UNEXPECTED compliance flag
An output compliance error occurred while the
output circuit was inactive
A
UNEXPECTED HV power supply flag
A high voltage output error occurred while the
high voltage circuit was inactive
A
UNEXPECTED multiple fail flags A
UNEXPECTED over temperature flag
An over-temperature error occurred while the
temperature measurement circuit was inactive
A
UNEXPECTED Output clamp overload A
UNEXPECTED Power amp overload
A power amplifier overload error occurred
while the power amplifier was inactive
A
Unknown keycode
The keyboard encoder has produced an
unrecognised code
B
Up range required B
Using default DAC factors D
UUT sense current is high. Internal circuits saturated.
Change current setting B
UUT sense current is high. Internal circuits saturated.
Output outside specification B
UUT sense current is low.
Output outside specification B
V
Entered value is outside of the allowed range B
W
Width too big B
Width too small B
Y
Year entry is not a valid number F
Year separator is incorrect F
Error Messages
18
www.valuetronics.com