INSTALLATION MANUAL
2
NEVER HANDLE A PUMP or motor with wet hands or when
standing on a wet or damp floor while the pump is plugged into
the power supply.
WASH HANDS AFTER HANDLING. According to the state of
California (Prop 65), this product may contain chemicals known
to the state of California to cause cancer and birth defects or
other reproductive harm.
RISK OF ELECTRIC SHOCK. This pump has not been
investigated for use in swimming pool and marine areas.
DO NOT USE TO PUMP FLAMMABLE OR EXPLOSIVE
FLUIDS such as gasoline, fuel oil, kerosene, etc. Do not use in a
flammable and/or explosive atmosphere. Pump should only be
used to pump clear water. Personal injury and/or property
damage could result.
PUMPS ARE NOT DESIGNED TO TRANSFER WATER
INTENDED FOR DRINKING. Do not use the pump for moving
water that will be used for potable/drinking water. Pump
should only be used in applications for which it is designed.
2000 03 -015 2/16
CAUTION INDICATES A POTENTIALLY HAZARDOUS
SITUATION WHICH, IF NOT AVOIDED, MAY RESULT
IN MINOR OR MODERATE INJURY.
TO REDUCE THE RISK OF HAZARDS THAT CAN
CAUSE INJURY OR PROPERTY DAMAGE,
OBSERVE THE FOLLOWING WARNINGS:
IT IS RECOMMENDED TO USE A CHECK VALVE with this pump
to prevent the back-flow of fluid after each pump cycle.
DO NOT INSTALL OR OPERATE THE PUMP IF IT HAS BEEN
DAMAGED IN ANY WAY.
DO NOT LIFT OR CARRY THE PUMP BY THE POWER CORD.
Use the pump’s handle.
IF THIS PUMP CONTAINS A SWITCH FOR AUTOMATIC
OPERATION, IT IS THE INSTALLER’S RESPONSIBILITY TO
MAKE SURE THE SWITCH IS ABLE TO OPERATE WITHOUT
ANY OBSTRUCTIONS WITHIN THE BASIN. It is
recommended that the installer test and observe the pump’s
operation for several cycles after installation.
DO NOT USE THIS PUMP IN MUD, SAND, CEMENT, OIL OR
CHEMICALS.
DO NOT USE SUMP AND EFFLUENT PUMPS TO HANDLE
RAW SEWAGE.
IT IS RECOMMENDED TO USE RIGID PIPING AND FITTINGS
to secure the pump in the basin and reduce pump movement.
Pump movement can prevent the switch from operating
correctly.
AN INDEPENDENT HIGH WATER ALARM OR BACK UP PUMP
SHOULD BE USED when risk of property damage from high water
levels exists
THIS PUMP SHOULD BE INSPECTED 3 TO 4 TIMES PER
YEAR for pump movement or buildup of debris on the switch or
float. Reposition pump if it has moved. Remove any debris that
could interfere with the operation of the switch.
THE SWITCH SHOULD BE REPLACED EVERY TWO (2)
YEARS. This maintenance will reduce the risk of improper pump
operation, switch failure, or flooding.
TYPICAL SUMP INSTALLATION DIAGRAMS
Figure 1: Submersible Sump
To Next Page
Loading...
Need help?
General
