What to do if my Wayne EEAUP250 runs continuously?
If your Wayne Water Pump runs continuously, it might be due to debris stuck inside the sensor body. To resolve this, unplug the unit and check for any trapped leaves, debris, or dirt inside the sensor body. Remove any obstructions you find.
Why does my Wayne Water Pump cycle on and off too often?
If your Wayne Water Pump cycles on and off too often, the electronic switch may need cleaning. Unplug the pump, turn it upside down, and gently clean inside the switch housing with a small brush using soapy water.
How to troubleshoot a Wayne EEAUP250 that fails to operate?
If the Wayne Water Pump fails to operate, verify that the pumping height does NOT exceed 15 feet and that the water depth is 1-3/4 inches or greater. Also, try this: disconnect the pump from the power source, connect the hose adapter and discharge hose, immerse the pump in water, and then plug it into a power outlet.
Details on power requirements, motor, construction materials, and discharge specifications.
Table showing pump performance (Gal/hr) at various discharge heights.
Details pump features, power cord, discharge adapter, and unpacking inspection.
Explains safety symbols (DANGER, WARNING, CAUTION, NOTICE) and general safety warnings.
Warning regarding chemicals known to cause cancer and reproductive harm.
Safety warnings for handling pump with wet hands, electrical hazards, and proper plug use.
Steps for connecting discharge, ensuring hose washer, unwinding hose, and setting pump.
Details on automatic start/stop, priming delay, and not running dry.
Instructions for periodic cleaning of the pump, including base and impeller.
Information on maximum pumping height and the necessity of a check valve.
Verifying pumping height, water depth, and proper operation sequence.
Troubleshooting for blockages, debris in sensor, and frequent cycling.
Chart listing pump symptoms, possible causes like breaker trips or obstructions.
Steps to fix issues such as resetting breakers, cleaning parts, or adjusting height.
Details the one-year limited warranty, exclusions, and how to make a claim.
General| Model | EEAUP250 |
|---|---|
| Category | Water Pump |
| Type | Submersible |
| Max Flow Rate | 1800 GPH |
| Max Head | 25 ft |
| Cord Length | 10 ft |
| Voltage | 115 V |
| Housing Material | Thermoplastic |
| Impeller Material | Thermoplastic |
| Thermal Protection | Yes |
| Discharge Size | 1 inch |
| Outlet Size | 1 inch |
| Shaft Seal | Mechanical |
To Next Page
