It’s not recommended to modify the control port, for details about the value ranges of the
control port, HTTP port and RTSP port, see the communication matrix.
Step 3 Click Apply.
If the message "Apply success!" is displayed, and the system saves the settings.
If the message "Invalid Control Port, Please input an integer between 1025 and
65535" is displayed, enter correct port numbers.
----End
4.4.6 Configuring the Date and Time
Description
On the Date and Time page, you can modify the date and time. Parameters that can be
set include:
Time zone and daylight saving time (DST)
Date and time
Network Time Protocol (NTP) server
Procedure
Step 1 Choose Configuration > Device > Date and Time.
The Date and Time page is displayed, as shown in Figure 4-13. Table 4-8describes the
parameters.
To Next Page
Loading...
Need help?
General
