14
4.1 Start display after switching on
The following information about the connected heater and control
element is shown in the start display:
■
Name of the connected control element
■
Name of the connected heater
■
Software version of the connected control element
■
Hardware version of the connected control element
The view returns to the main menu after 1.5 seconds.
50 Eco
MultiControl
ThermoPro
SW: 1.2.2
4.2 Air heaters
4.3 Heating set-up
Three heating modes* can be selected:
Eco (energy saving mode)
Normal (comfort heating)
Boost (rapid heating)
They differ in terms of energy consumption and time during which the set tem-
perature is reached. Eco heating programme needs the least energy. However, it
takes more time to reach the set temperature.
* depending on the installed heater.
4.3.1 Switching on the heater by means of quick start button
“Quick start” function enables heating or ventilation by simply pressing the but-
ton. In heating mode one can preset heating mode, temperature, operating time.
Instruction manual and description of the settings can be found in the chapter
“Setting the quick start”.
To Next Page
Loading...
Need help?
General
