51
Press the control knob in order to confirm
selection.
The heater name is shown in the display.
Heater
Settings
Turn the control knob in order to switch
between the names of the heater and information
regarding control element (the name of the con-
trol element, status of software and equipment).
Settings
4.21 Displaying stored error information
If heaters and other connected components show malfunctioning then such
error information codes) is saved and displayed here. Current error information is
additionally marked with “!” symbol.
When an error occurs, error information must be confirmed by pressing the con-
trol knob. The main menu is displayed once again only after confirmation.
3
“Settings” symbol has been selected in the main menu.
Settings
Press the control knob.
“Quick start” symbol is shown in the display.
Quick start
Settings
To Next Page
Loading...
Need help?
General
