Webasto TSL 17 Coolant Heater
Webasto Product N.A., Inc. 5 www.webasto.us
Operating the Coolant Heater with the OPTIONAL 7-Day Digital Timer
Setting the Time and Day of the Week
1
Press and hold for 2 seconds. Time of day will start flashing.
2
Press Or to adjust time setting. Once time is set, release button.
Flashing will stop after 5 seconds and day of the week will begin flashing.
3
Press Or to select the day of the week. Once set, wait for flashing to stop.
Operating the Heater in Manual Mode
1
Press to activate the heater. The operation indicator will light up.
2
Press to deactivate the heater. The operation indicator will go out.
Programming Heater Starting Times
1
Press to begin timer programming. The timer memory selection number starts flashing.
Continue to press button until the desired memory selection number (1, 2 or 3) is visible.
2
Press Or to adjust heater start time setting. Once start time is set, release button.
Flashing will stop after 5 seconds and day of the week will begin flashing.
3
Press Or to select day of the week. Once set, wait for flashing to stop.
The heater will start on the time and day selected. To program the other two
memory locations, repeat the above 3 steps for each location.
Recalling or Cancelling a Programmed Starting Times
1
Press to cycle through the selection numbers. Any one of the three memory numbers can be activated
each time the button is pressed.
After selecting the memory number you desire, you can recall or change the day and time setting
if desired be repeating steps 1, 2 and 3 under “Programming Heater Starting Times”.
2
Press repeatedly until no memory location number is visible on the timer display.
Day of
the Week
On/Off
Operation
Indicator
Time of Day
and Timer Display
Timer Memory Selection
Number
Clock Button
Program
Selection
Button
Heater
On/Off
Button
Day/Time
Reverse
Button
Day/Time
Forward
Button
Operating Instructions
To Next Page
Loading...
Need help?
General