MOWING TIPS
Under certain conditions, such as very tall grass, it may be necessary to raise the height of cut to
reduce pushing effort, prevent overloading of the motor and leaving clumps of grass clippings.
It may also be necessary to reduce ground speed and/or push the lawn mower over the area a
second time. For extremely heavy cutting, reduce the width of cut by overlapping the previously cut
path and mow slowly. The side combs allow the machine to cut up to walls.
When cutting on slopes, ensure your footing is secure, the grass is not wet and the machine is
used across the slope and not up or down the slope. The slope gradient should not exceed 15°.
ADJUST THE CUTTING HEIGHT
Raise the wheels for a low cut and lower the wheels for a high cut, adjust the cutting height to suit
your requirements. Medium position is best for most lawns.
The single height adjustment lever is located on the front axle, left wheel.
Push the lever towards the wheel and rotate up or down the five settings, depending on your needs.
GRASSBOX FULL INDICATOR
Your machine grassbox collector is fitted with a full indicator at the rear of the hard top. Whilst air is still
rotating around the collector and grass is being collected, the flap will raise and remain open. Once
the collector is full, the flap will remain closed and you should empty the grassbox.
WEER33 Instruction Manual.indd 12 20/10/2016 14:11
To Next Page
Loading...
