BRUSHCUTTER
Always keep a firm grip with both hands during operaon
The machine should be held at a comfortable posion, with the trigger handle at hip height. Adjust the
harness to suit.
Maintain a firm foong in case the machine hits a solid object & kicks back.
Do not use the metal blade near fencing, posts, buildings or other immoveable objects – use the nylon
head.
Best results are obtained if you cut from right to le, in a broad sweeping moon.
If a hard object is struck
, immediately stop the machine and inspect for damage.
WARNING
DO NOT use the put the metal blade into contact with Ulity Wires, Metal Stakes, Rubber, Masonry, Rocks,
Fences, and Trees.
DANGER
DO NOT cut with a dull, cracked or damaged metal blade.
Before cung, inspect for obstrucons. If an obstrucon cannot be removed, mark its locaon clearly so you
can avoid it during operaon.
Rocks & metal can dull or damage a blade. Wires can wrap around the blade head or be thrown in the air.
SCYTHING WEED
S
This is cung by swinging the blade in a level arc. It can quickly clear areas of field grass and weeds. Scything
should not be used to cut large, tough weeds or woody growths.
Scything can be done in both direcons, or just in one way which results in the debris being thrown away from
you. This is done by using the side of the blade that it is rotang away from you. Tilt the blade downwards
slightly, on this same side .You will be hit by some debris if you scythe in both direcons
INSTRUCTION MANUAL
To Next Page
Loading...
