Webb WEMC26 - TROUBLE SHOOTING

TROUBLE SHOOTING
Failures such as a difficulty in starng the engine, irregularity in funcons and abnormality in performance can normally be
prevented if careful aenon is paid to all operang instrucons & maintenance procedures.
Should the engine not funcon properly, check the following?
 That the fuel system is in good condion and fuel is flowing to the engine.
 The ignion system is in good condion and the spark plug, sparks correctly.
 Compression of the engine is adequate. (service dealer assistance required to diagnose)
FAILURE TO START
 Correctly follow the starng procedure, not seng the choke lever or priming the engine can cause it not start.
 Ensure that fuel is fresh and clean. Dispose of fuel from the tank, parcularly if over 30 days old.
 Install a new, properly gapped spark plug.
 When there is serious trouble with the unit, have your local approved service dealer inspect it for you.
POWER UNIT - PROBLEM
POSSIBLE CAUSE
SOLUTION
Non Start, Power Loss or Sudden Stop
1. Fuel Tank Empty
2. Mixture not reaching carburetor
3. Water in fuel mixture
4. The Air Filter is dirty
5. Carbon deposits in cylinder or
exhaust.
1. Add Fuel
2. Drain & rinse mixture from fuel system
3. Clean Fuel Filter
4. Clean Air Filter
5. Clean all affected parts or change exhaust
Engine runs but head not rotang
Possible clutch failure
Take to authorised service/repair dealer
Power Unit is smoking
Incorrect fuel/oil mixture
Drain tank & use 40 parts unleaded fuel to 1
part mineral oil (40:1). For semi & synthec oils,
us manufacturer raos
Idle is lumpy or aachment rotang
without trigger depressed
Fuel Mix/Idle Screw is incorrectly
adjusted
Take to authorised service/repair dealer
LINE TRIMMER - PROBLEM
POSSIBLE CAUSE
SOLUTION
Line will not advance
1. Line is welded to itself
2. Insufficient line on spool
3. Line has worn too short
4.
Line is tangled in spool
1. Lubricate with silicone spray
2. Add more line
3. Bump head on ground to feed line.
4.
Remove line from the spool & rewind
Trimmer head is difficult to rotate
Build up of grass or grass wrapped
around head
Clean head by removing grass
Grass wrapping around aachment sha &
head assembly
Cung tall grass at ground level
Cut tall grass in stages, from the top down
PRUNER - PROBLEM
POSSIBLE CAUSE
SOLUTION
Difficult to cut branches
Chain is blunt
Change chain or arrange for sharpening
Chain is smoking
Lack of lubricaon
1. Check that oil duct is clear
2.
Top up the oil canister with chain oil
Chain not rotang
1. Chain too ght
2.
Chain Sprocket faulty
1. Adjust chain tension
2.
Replace
HEDGECUTTER - PROBLEM
POSSIBLE CAUSE
SOLUTION
Blades not reciprocang
1. Blades fused by sap
2. Gear head issue
1. Lubricate with Mul-purpose spray and
leave to soak
2.
Take to authorised service/repair dealer
BRUSHCUTTER - PROBLEM
POSSIBLE CAUSE
SOLUTION
Vibraon through machine
Blade has been incorrectly assembled
Strip down blade assembly, follow instrucons.