PRUNER
WARNING
The Pruner is supplied with a low KICKBACK chain, however somemes kick back can occur, so always hold
the unit firmly in two hands. The Kickback danger zone on your Pruner is the upper part of the nose of the
guide bar. Never saw using this part of the guide bar, which poses a significant risk for kickback.
Posion the hook located on the boom of the head against the branch, to reduce the risk of the pruner
jerking forward.
Ensure the chain is running in the correct direcon.
Thin branches can be removed with a single cut, but if the branch is long, it is preferable to cut it in several
pieces, moving towards the main trunk of the tree.
Always check for any damage before each use and replace a damaged chain immediately, with an
approved replacement part.
Before every use, check the level of the chain oil in the reservoir.
During use, check the tension of the chain. (See Maintenance Secon For Instruc
on)
Always fit the supplied blade guard when the Pruner Aachment is not in use.
For larger branches, the 3-point method should be used to prevent breakage.
Do not work at an angle, higher than 60 degree’s, there is a danger of being injured by branches falling
without warning. Also be careful not to trip over grounded branches.
To Next Page
Loading...
