Weber mt CF 2 - 3.2.2 Routine Maintenance

3.2.2 Routine Maintenance
22 CF-2
Maintenance
Interval
Maintenance
Item
Remarks/
Notes
Every 8 ope ra ting hours
Whole machine -
Check for visible damage,
leaks etc.
Air filter -
Clean and check the air filter
element for damage, replace it
if required
# 3.3.2
Engine - Check the engine oil level # 2.4.2
Vibrator -
Check, and if required,
increase the V-belt tension
# 3.3.4
Engine - Change the engine oil # 3.3.1
- Clean the spark plug
-Clean the air filter # 3.3.2
Every 100 ope ra ting
hours
Whole machine -
Check all screwed
connections for tight seat,
retighten them if necessary
Engine - Clean the fuel filter # 3.3.2
-
Clean the spark plug and
adjust the air gap
Manual of the
engine
manufacturer
All bare parts - Apply a slight film of oil
Every 500 ope ra ting
hours
Vibrator - Change the oil # 3.3.6
Engine -
Clean, and if required, adjust
the carburettor
Manual of the
engine
manufacturer
-Clean the cylinder head
-Adjust the valve cleance
Whole machine -
Check all groups for visible
damage and wear
-
Remove dirt, old grease and
rust
Every 200 ope ra ting
hours
Every 2000 operating
hours
Maintenance Work
Every 50 ope ra ting
hours