CR 1_CR 2R 17
The regulations of the engine manufacturer must be complied with in addition to the above
maintenance overview!
Work must be carried out using regulation tools, and the operating and maintenance manual
must be complied with for all work.
All maintenance work: Select a collection vessel that is large enough to prevent oil from
spilling onto the ground. Dispose of waste oil in an environmentally friendly manner (regulation
on waste oils).
Dispose of oils, greases, cloths soaked in oil, and replaced parts with oil on them in an environ-
mentally friendly manner.
If lubricating oils and fuel come into contact with skin, they can cause skin cancer. Upon contact
with the skin, clean affected skin with suitable cleaning agent without delay.
If accessible during maintenance, check the condition and stability of all screws.
Maintenance overview
Maintenance interval Maintenance point Maintenance activity
After the rst
10 operating hours
Engine – Change the engine oil
– Re-tighten all accessible
threaded connections
Every 8 operating
hours / daily
Air lter – Clean air lter insert,
check for damage,
replace if necessary
Every 50 operating
hours / every 6 months
Engine – Change the engine oil
– Change the fuel oil
Every 150 operating
hours / every year
Transmission
Exciter
– Change oil
– Change oil
To Next Page
Loading...
