13
Figure 6
Single bushing
at left
Two bushings
at right
Step 7
Check the frame assembly
To avoid having to disassemble your barbecue in a later
step, check the positioning of the front frame connector
before continuing with the assembly.
Turn the frame assembly over. The front frame connector
should correspond with Figure 6.
Step 8
Install left end panel
You will need: frame assembly and left end panel.
(Number 1)
Place the bottom of the left end panel on the caster
frame lower cross piece. Set the end panel upright in
place. Figure 7.
Figure 7
Step 6
Insert casters
You will need: frame assembly and two casters.
Push the casters firmly into the caster inserts in the
ends of the caster legs. Figure 5.
Figure 5
To Next Page
Loading...
