29
Step 33
Complete accessory installation
You will need: work table, serving tray, Warm-Up Basket,
warming rack, thermometer, two tubing plugs and a
hammer.
Insert one end of the Weber Warm-Up Basket into the
hole in the right end of the lid and the other end into the
slot in the left end of the lid. Figure 48 (a).
Set the work table onto the left side rails. Figure 48 (b).
Place porcelain serving tray on the work table.
Figure 48 (c).
Set the warming rack into the slots at the rear of the
cooking box. Figure 48 (d).
Insert the thermometer into its holder. Figure 48 (e).
Insert tubing plugs into the ends of the frame. To fully seat
the plugs, you may have to tap them lightly with a
hammer. Figure 48 (f).
Figure 48
(a)
(d)
(e)
(f)
(b)
(c)
CAUTION: To keep the barbecue stationary, the
tabs on the locking casters should be in the down
position.
To Next Page
Loading...
