Weber Genesis 310 User Manual (English)

Other manuals for Weber Genesis 310

Owner's Guide23 pages

User Manual2 pages

Questions and Answers:

A
Amanda WoodsJul 26, 2025
Why Weber Genesis 310 Grill burner does not ignite when I push the igniter button?
- J
  Julia GarciaJul 26, 2025
  If your Weber Grill burner does not ignite when you push the igniter button, and match lighting is successful, the problem lies in the ignition system. Refer to “ELECTRONIC IGNITION SYSTEMS OPERATIONS”. Verify that the battery is in good condition and installed correctly. Refer to “ELECTRONIC IGNITER INSPECTION”. Be sure that wires are correctly inserted into terminals on the ignition box. Refer to “ELECTRONIC IGNITION SYSTEMS OPERATIONS”. Remove any plastic wrapping.
M
Matthew BranchAug 1, 2025
What to do if I am experiencing flare-ups on my Weber Grill?
- E
  efloresAug 1, 2025
  To address flare-ups on your Weber Grill, ensure you preheat all burners on HI for 10 to 15 minutes. Clean cooking grates, heat deflectors, and Flavorizer® bars if they are heavily coated with burned-on grease. Also, clean the slide-out grease tray to ensure grease flows into the catch pan.
R
Russell MasonAug 7, 2025
Why is the burner flame pattern erratic on my Weber Genesis 310?
- K
  Kathryn ValenciaAug 7, 2025
  If the burner flame pattern is erratic on your Weber Grill, with a low flame even when on HI, and the flames don't run the entire length of the burner tube, the burners may not be clean. Clean the burners following the instructions in the “MAINTENANCE” section.
D
Diana Luna PhDAug 13, 2025
Why do my Weber Genesis 310 burners have yellow flame?
- R
  Ronald ClarkAug 13, 2025
  If the burners on your Weber Grill burn with a yellow or orange flame and you smell gas, clean the Spider/Insect screens. Refer to “ANNUAL MAINTENANCE”.
M
Michelle DawsonAug 18, 2025
How to align the cabinet doors on my Weber Genesis 310 Grill?
- E
  Emily EvansAug 18, 2025
  To align cabinet doors on your Weber Grill, loosen the adjustment nut/s, slide the door/s until they are aligned, and then tighten the nut/s.