Weber GENESIS A103.A User Manual

C-6
Check for gas leaks
m DANGER
Do not use an open flame to check for gas
leaks. Be sure there are no sparks or open
flames in the area while you check for
leaks. Sparks or open flames will result in
a fire or explosion, which can cause
serious bodily injury or death and damage
to property.
m WARNING: You should check for gas leaks every
time you disconnect and reconnect a gas fitting.
Note - All factory-made connections have been
thoroughly checked for gas leaks. The burners have
been flame-tested. As a safety precaution however, you
should recheck all fittings for leaks before using your
Weber Gas Barbecue. Shipping and handling may
loosen or damage a gas fitting.
m WARNING: Perform these leak checks even if
your barbecue was dealer or store assembled.
You will need: a soap and water solution, and a rag or
brush to apply it.
Note - Since some leak test solutions, including soap
and water, may be slightly corrosive, all connections
should be rinsed with water after checking for leaks.
Make sure side burner is OFF.
To perform leak checks: Slide back the collar of the
quick disconnect. Push the male fitting of the hose into
the quick disconnect, and maintain pressure (1). Slide
the collar closed (2). If it does not engage or lock,
repeat procedure. Gas will not flow unless the quick
disconnect is properly engaged.
Turn on gas supply.
Check for leaks by wetting the connections with the
soap and water solution and watching for bubbles. If
bubbles form or if a bubble grows, there is a leak.
Note – Since some leak test solutions, including soap
and water, may be slightly corrosive, all connections
should be rinsed with water after checking for leaks.
m WARNING: Do not ignite burners when leak
checking.
(1)
(2)

Weber GENESIS A103.A Specifications

General

Brand	Weber
Model	GENESIS A103.A
Category	Grill
Language	English