PROBLEM CHECK CURE
Burners burn with a yellow or orange flame, in Inspect Spider / Insect Screens for possible obstructions. Clean Spider / Insect Screens. (See Section 'Annual
conjunction with the smell of gas. (Blockage of holes.) Maintenance")
Burner does not light, or flame is low in "HI" Is fuel hose bent or kinked? Straighten fuel hose.
position.
Experiencing flare-ups:
Does the burner light with a match?
Are you preheating barbecue in the prescribed manner?
If you can light Burner 1 with a match, then check the
Crossover _ ignition system.
All burners on "HI" for 10 to 15 minutes for preheating.
CAUTION: Do not line the bottom tray with
aluminum foil.
Are the cooking grates and Flavorizer _ bars heavily Clean thoroughly. (See Section "Cleaning")
coated with burned-on grease?
Is the bottom tray "dirty" and not allowing grease to flow Clean bottom tray.
into catch pan?
Burner flame pattern is erratic. Flame is low when Are burners clean? Clean burners. (See Section "Maintenance':)
burner is on "HI." Flames do not run the whole
length of the burner tube.
inside of lid appears to be "peeling." (Resembles The lid is porcelain enamel or stainless steel, not paint. Clean thoroughly. (See Section "Cleaning'.')
paint peeling.) It cannot "peer_What you are seeing is baked on grease
that has turned to carbon and is flaking off.
THIS IS NOT A DEFECT.
Cabinet doors are not aligned. Check the adjustment pin on the bottom of each door. Loosen adjustment nut/s. Slide door/s until aligned. Tighten
nut.
if problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web
site. Log onto www.weber.com ®.
PROBLEM CHECK CURE
Side Burner does not light. Is gas supply off? Turn supply on.
Flame is low in "HI" position Is the fuel hose bent or kinked? Straighten hose.
Push button ignition does not work. Does burner light with a match? If match lights burner, check igniter (see below).
if problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web
site. Log onto www.weber.com ®.
To Next Page
Loading...
Need help?
General