26
Troubleshooting
Problem
Burner burns with a yellow or
orange flame, in conjunction
with the smell of gas.
Burner does not light, or flame
is low.
Burner flame pattern is erratic.
Inside of lid appears to be
“peeling.”(Resembles paint
peeling.)
CharBin slides out of the frame
brace.
Check
Inspect burner for possible
obstructions.
Is flow limiting device activated?
Is LP fuel low?
Is fuel hose bent or kinked?
Does the burner light with a match?
Is test valve open?
Is the burner clean?
The lid is porcelain-on-steel, not
paint. It cannot “peel.” What you
are seeing is baked on grease that
has turned to carbon and is flaking
off. THIS IS NOT A DEFECT.
The position of the Cooking grate
holder. It may be sitting on the
frame brace incorrectly.
Cure
Clean burner. See Section
"Maintenance."
(See Section "Lighting
Instructions".)
Refill LP tank.
Straighten fuel hose.
If you can light the burner with a
match, then check the Ignition
System. See Section
"Maintenance."
Turn test valve to the open
position.
Clean burner, See Section
"Maintenance."
See Section "Periodic Cleaning."
Reposition the Cooking grate
holder. See Step 12.
To Next Page
Loading...
Need help?
General