Weber SLATE GP17 - Troubleshooting; Replacement Parts

11weber.com
Lighting Your Barbecue with a Match
1) Open the protective top cover.
m WARNING: Do not operate the barbecue with the top cover
closed. The top cover is to be used for storage purposes
only to protect the griddle.
2) Check that the burner control knob is in the
o
position. Check by pushing in and turning knob
clockwise.
Note: It is important that the burner control knob is in the
o position before turning on the ULPG cylinder. If they
are not, the flow limiting device built into the regulator will
activate, limiting the flow of gas from the ULPG cylinder. To
reset the flow limiting device see instructions below.
3) Confirm that the cartridge/cylinder is properly installed
and gas is on. Refer to “Installing the Propane Cartridge/
Cylinder Installation."
Note: If using a ULPG cylinder, it is important that the ULPG
cylinder is turned on slowly. Ifit is opened too quickly, the
flow limiting device built into the regulator will activate,
limiting the flow of gas from the ULPG cylinder. To reset the
flow limiting device see instructions below.
4) Put a match in the matchstick holder and strike match.
Insert lit match through the slot on the side of the griddle
(A).
5) While holding lit match, push the burner control knob in
and turn it counterclockwise to the start/high
position.
6) Check that the burner is lit by looking through the slot on
the sides of the griddle.
7) If the burner does not ignite within 5 seconds, turn
burner control knob to the o
position and wait five
minutes to allow the gas to clear before attempting to
light the burner again. After repeated attempts follow
the gas flow troubleshooting instructions above.
8) If the burner ignites the problem may be with the ignition
system. Contact Weber Customer Service about checking
the ignition system.
A
BARBECUE WILL NOT IGNITE
SYMPTOM
• Burner does not ignite when following the ignition instructions in the “Operation” section of this Owner's Manual.
CAUSE SOLUTION
There is a problem with gas flow. If the barbecue will not ignite, the first step is to determine if there is gas flowing to the burners. Tocheck this, follow the
instructions below for “Using a Match to Determine if there is Gas Flow to the Burners.”
If match lighting IS NOT successful, follow the instructions for disconnecting and reconnecting the propane cartidge or ULP
gas cylinder. If using a ULP gas cylinder, reset the flow limiting device in the regulator. See instructions at bottom of page.
There is a problem with the ignition system. If the barbecue will not ignite, the first step is to determine if there is gas flowing to the burners. Tocheck this, followthe
instructions below for “Using a Match to Determine if there is Gas Flow to the Burners.”
If match lighting IS successful, check the condition of the wire connections of the IgnitionSystem.
TROUBLESHOOTING
Regulator Flow Limiting Reset Guide.
1) Turn o barbecue control knob. There is no need to turn
o the gas cylinder.
2) Wait 30 seconds.
3) Open the top cover.
4) Light barbecue per lighting instructions on page 8.
NOTE: Always turn your barbecue control knob o before
turning o your gas cylinder.
CALL CUSTOMER
SERVICE
If you are still experiencing any problems,
contact Weber ANZ Customer Service or
visit weber.com.
Australia 1300 301 290
New Zealand 0800 493 237
REPLACEMENT PARTS
To obtain replacement parts,
contact Weber ANZ Customer Service or
visit weber.com.
Australia 1300 301 290
New Zealand 0800 493 237