Weber SLATE GP30 User Manual

TROUBLESHOOTING
CALL CUSTOMER
SERVICE
If you are still experiencing any
problems, contact the CustomerService
Representative in your area using the
contact information on weber.com.
REPLACEMENT PARTS
To obtain replacement parts,
contact the local retailer
in your area or log onto weber.com.
U.S.:
1-800-446-1071
Mexico:
01 800 0093237
Canada:
1-800-446-1071
PROBLEMS? QUESTIONS? Do Not Return Product to the Store. We Can Help.
If you have questions about the assembly, use, or maintenance of your grill or need replacement parts, please contact Weber
Customer Service. The serial number and model number can be
found on the cover of your owner’s manual and will be necessary for all service calls.
© 2023 Designed and engineered by Weber-Stephen Products LLC, 1415 S. Roselle Road, Palatine, Illinois 60067 USA.
MAIN BURNER(S) WILL NOT IGNITE
SYMPTOM
• Main burners do not ignite when following the ignition instructions in the “Operation” section of this owner's manual.
CAUSE SOLUTION
There is a problem with gas flow. If any burner does not ignite, the first step is to determine if there is gas flowing to the burner(s). Tocheck this, follow
the instructions below for “Lighting Your Grill with a Match.”
If match lighting IS NOT successful, follow the instructions for disconnecting and reconnecting the LP tank..
There is a problem with the ignition system. If any burner does not ignite, the first step is to determine if there is gas flowing to the burner(s). Tocheck this, follow the
instructions below for “Lighting Your Grill with a Match.”
If match lighting IS successful, contact customer service about checking the ignitionsystem.
C
Lighting Your Grill with a Match
Using a Match to Determine if there is Gas Flow to
the Main Burners
Matchstick holder is available on select models only.
1) Remove the protective hard cover.
m WARNING: Do not operate the grill with the hard
cover closed. The hard cover is to be used for storage
purposes only to protect the griddle.
2) Check that all burner control knobs are in the o
position. Check by pushing in and turning knobs
clockwise.
Note: It is important that all burner control knobs are in
the o position before turning on the LP tank. If they
are not, the flow limiting device built into the regulator will
activate, limiting the flow of gas from the LP tank.
3) Turn the LP tank on by slowly turning the tank valve
counterclockwise; wait 60 seconds.
Note: It is important that the LP tank is turned on slowly.
Ifit is opened too quickly, the flow limiting device built into
the regulator will activate, limiting the flow of gas from
the LP tank.
4) Begin with the burner furthest to the left. Put match
in the matchstick holder and strike match. (Matchstick
holder is located inside the rear right leg of the grill.)
Insert lit match through the slot on the side of the
griddle, next to the burner(A).
5) Pushthe burner control knob in and slowly turn it
counterclockwise to the start/high
position (B).
6) Confirm that the burner is lit by looking bewteen the
griddle and the grill frame.
7) If the burner does not ignite within 4 seconds, turn
burner control knob to the o
position and wait five
minutes to allow the gas to clear before attempting to
light the burner again. If repeated attempts fail, follow
the gas flow troubleshooting instructions on the next
page.
8) If the burner ignites, the problem may be with the
ignition system. Contact WEBER customer service
about checking the ignitionsystem.
9) Replace the matchstick holder by hanging it inside the
rear right leg of the grill (C).
B
A

Weber SLATE GP30 Specifications

General

Brand	Weber
Model	SLATE GP30
Category	Griddle
Language	English