6
INSIDE ANTENNA OPTIONS
Slim Low Profile
301152 - w/ 10’ RG174
Low Profile
311106 - w/ 10’ RG58
OUTSIDE ANTENNA OPTIONS
Mini-Mag
301126 w/ 12 5 RG174 cable- SMA
301113 w/ 12.5 RG174 cable - FME
12” Mag Mount
311125 w/ 12.5’ RG174
311128 w/ 12.5’ RG174
314202 w/ 12.5’ RG174
Trucker Antenna
311101 w/10 5’ RG58
311701 w/10.5’ RG58
Trucker Antenna
311119 w/13.5’ RG58
311133 w/13.5’ RG58
Marine Antenna
311130-5810 w/10.5’ RG58
Glass Mount
311102 w/14’ RG58
311114 w/14’ RG58
NMO Antenna
Kit 311104-5810
• 800/1900 NMO Antenna
• 10’ RG58 Cable
Kit 311112-5810
• 800/1900 NMO Antenna
• 10’ RG58 Cable
Kit 314203-5810
• 800/900/1900 NMO Antenna
• 10’ RG58 Cable
Kit 311104-17410
• 800/1900 NMO Antenna
• 10’ RG174 Cable Kit 311104-40015
Kit 311112-17410
• 800/1900 NMO Antenna
• 10’ RG174 Cable
Kit 314203-17410
• 800/900/1900 NMO Antenna
• 10’ RG174 Cable
Antenna Kit Options
BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider
and have your provider’s consent. Most wireless providers consent to the use of
signal boosters. Some providers may not consent to the use of this device on their
network. If you are unsure, contact your provider.
You MUST operate this device with approved antennas and cables as specified by
the manufacturer. Antennas MUST be installed at least 20 cm (8 inches) from any
person.
You MUST cease operating this device immediately if requested by the FCC or a
licensed wireless service provider.
WARNING. E911 location information may not be provided or may be inaccurate
for calls served by using this device.
This is a CONSUMER device.
Safety Guidelines
Warning: In a wireless installation, do not plug the Signal Booster directly into the cell phone or cellular data card
using an antenna adapter. It will damage the Signal Booster, cell phone or cellular data card.
Warning: Do not plug in the DC power supply until the Outside and Inside Antenna cables are attached to the
Signal Booster.
Warning: The Inside Antennas must have a 1.5 feet of separation distance from all active users.
Warning: RF Safety: Any antenna used with this device must be located at least 8 inches from all persons.
Warning: Use only the power supply provided in this package. The power supply must be 6 V DC Output.
This device complies with Part 15 of FCC rules. Operation is subject to two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation. Changes or modifications not expressly approved by weBoost could void the authority to operate this
equipment.
Each Signal Booster is individually tested and factory set to ensure FCC compliance. The Signal Booster cannot be
adjusted without factory reprogramming or disabling the hardware. The Signal Booster will amplify, but not alter incoming
and outgoing signals in order to increase coverage of authorized frequency bands only. If the Signal Booster is not in use
for five minutes, it will reduce gain until a signal is detected. If a detected signal is too high in a frequency band, or if the
Signal Booster detects an oscillation, the Signal Booster will automatically turn the power off on that band. For a detected
oscillation the Signal Booster will automatically resume normal operation after a minimum of 1 minute. After 5 (five) such
automatic restarts, any problematic bands are permanently shut off until the Signal Booster has been manually restarted
by momentarily removing power from the Signal Booster. Noise power, gain, and linearity are maintained by the Signal
Booster’s microprocessor.
To Next Page
Loading...
Need help?
General