EasyManuals Logo

weBoost Drive Reach Fleet User Manual

weBoost Drive Reach Fleet
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
DRIVE REACH FLEET
PROFESSIONAL VEHICLE SIGNAL BOOSTER KIT
13
______
Specifi cations
NEED HELP?
Drive Reach
Model Number 4
60054
FCC ID: PWO4
60054
IC:
4
726A-4
60054
Co
nnectors
S
MB-
Jack
Antenna Impedanc
e
50
O
hms
Frequency
698-716 MHz, 728-756 MHz, 777-787 MHz, 824-894 MHz, 1850-1995 MHz, 1710-1755
/
2110-2155 MHz
Ma
ximum Power
Power output for single cell
phone (Uplink) dB
7
00
MHz
Band 12/1
7
2
7.
3
7
00
MHz
Band 1
3
2
7.1
800
MHz
Band
5
2
7.
0
17
00
MHz
Band 4
28
.4
1
9
00 MHz
Band 2/2
5
2
7.7
Power output
f
or single cell
phone
(
Downlink
)
dB
m
7
00
MHz
Band 12
/
1
7
5.
0
7
00
MHz
Band 1
3
5.
2
800
MHz
B
an
d
5
5.
2
2
1
00
MHz
Ba
n
d
4
5
1
9
00 MHz
Band 2
/
2
5
5
.
1
Noise Figure
5
dB
nomin
al
Isolation >
90
dB
Power Requirement
s
5
V 4.
5
A
Each Signal Booster is individually tested and factory set to ensure FCC compliance. The Signal Booster cannot be adjusted without
factory reprogramming or disabling the hardware. The Signal Booster will amplify, but not alter incoming and outgoing signals in order
to increase coverage of authorized frequency bands only. If the Signal Booster is not in use for fi ve minutes, it will reduce gain until a
signal is detected. If a detected signal is too high in a frequency band, or if the Signal Booster detects an oscillation, the Signal Booster
will automatically turn the power o on that band. For a detected oscillation the Signal Booster will automatically resume normal
operation after a minimum of 1 minute. After 5 (fi ve) such automatic restarts, any problematic bands are permanently shut o until the
Signal Booster has been manually restarted by momentarily removing power from the Signal Booster. Noise power, gain, and linearity
are maintained by the Signal Booster’s microprocessor.
This device complies with Part 15 of FCC rules. Operation is subject to two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifi cations not expressly approved by weBoost could void the authority to operate this equipment.
855.846.2654
SignalBooster.com

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the weBoost Drive Reach Fleet and is the answer not in the manual?

weBoost Drive Reach Fleet Specifications

General IconGeneral
BrandweBoost
ModelDrive Reach Fleet
CategoryExtender
LanguageEnglish

Related product manuals