weBoost DRIVE X User Manual

8
VEHICLE SIGNAL BOOSTER DRIVE X
ENGLISH
______
Light Patterns
Solid Green
This indicates that your booster is functioning properly and there are no issues with
installation.
Blinking Red, Then Solid Green
This indicates that one or more of the booster bands has reduced power due
to a feedback loop condition called oscillation. This is a built in safety feature
to prevent harmful interference with a nearby cell tower. If you are already
experiencing the desired signal boost, then no further adjustments are necessary.
If you are not experiencing the desired boost in coverage then refer to the
Troubleshooting section below.
Solid Red
This is due to a feedback loop condition called oscillation. This is a built in safety
feature that causes a band to shut off to prevent harmful interference with a nearby
cell tower. Refer to Troubleshooting section below.
Light O
If the Drive X Signal Booster’s light is off, verify your power supply has power.
NOTE: The Signal Booster can be reset by disconnecting and reconnecting
the power supply.
After troubleshooting you must initiate a new power cycle by disconnecting and
then reconnecting power to the Booster.
NEED HELP?
weboost.ca 866.294.1660

weBoost DRIVE X Specifications

General

Max Gain	50 dB
Impedance	50 Ohms
Connectors	SMA Female
Power Supply	12V DC
Cable Length	12 feet
Downlink	698-960 MHz, 1710-2700 MHz
Compatibility	All US carriers
Dimensions (Antenna)	6.5 x 4.5 x 1.5 inches
Weight (Antenna)	1.5 lbs