Weego 22 - Troubleshooting Common Issues; Smarty Clamps Connection Problems; Engine Not Starting After Jump

TROUBLESHOOTING
Visit myweego.com for FAQs and additional troubleshooting inquiries.
I can't get the Smarty Clamps® green light to appear
• Do you have a good connection?
A poor connection between the clamps and the terminals can be the
difference between a successful and failed jump. Adjust the clamps to
make sure theyre making maximum contact with your terminals, then try
again.
• Are your battery terminals dirty?
Build-up an your battery terminals can prevent you from getting a strang
connection. See your vehicle owner's manual far the best way to safely
remove buildup from your terminals.
I followed the necessary steps but my engine is still unable to start.
Now what?
• The green light appears, but the engine is not cranking.
Even if you get a green light an your Smarty Clamps®, the connection
may nat be strong enough. Reconnect the Smarty Clamps® in a more
secure manner and try again.
• Does yourWeego 22 have enough charge?
When using your Weega 22 peak performance is best achieved with a fuller
charge (greater than 80%, or 4/ights). If operating at less than 80%, we
suggest recharging your Weega 22, if possible.
• Your engine may be too large/powerful foryourWeego 22
Our batteries work hard to supply the power you need, but same engines
demand more than your Weega 22 can give. You may want to try the
11