Weego 22 - How to Jump Start Your Engine

JUMP STARTING YOUR ENGINE
1. Ensure your engine is completely OFF.
2. Securely connect the Smarty Clamps• to your
Weego 22, then power ON.
3. Place your Weego 22 in a secure location or
suspend using the provided hook & lanyard so it
won't fall.
4. Attach BLACK clamp to your battery's negative(-)
terminal, then the RED clamp to your battery's
positive ( +) terminal. Adjust your Smarty Clamps®
to achieve MAXIMUM contact with the terminals.
Poor connections will prevent you from starting your
engine! Clear off any dirt or buildup with a wire brush
or a dry towel before connecting your clamps.
5. Check your Smarty Clamps• lights. When you
have a GREEN READY light, start your engine. If the
engine doesn't start, check your Smarty Clamps•
lights and wait a minute before trying again.
6. After a successful start, disconnect the Smarty
Clamps• from yourWeego 22.
7. Detach the Smarty Clamps• from the battery.
8. You're now good to go - be sure to run your engine
for at least 15 minutes before shutting it off again so
it has time to recharge your battery.
If you are having issues getting your engine started,
see Troubleshooting (pages 11-12) for further
details and assistance.
9