Need help?Do you have a question about the WEG CFW09 and is the answer not in the manual?
General| Category | DC Drives |
|---|---|
| Enclosure Rating | IP20 |
| Power Rating | 2.2 kW |
| Protection | Overcurrent, Overvoltage, Overtemperature, Short Circuit |
| Humidity | 5% to 95% (non-condensing) |
| Communication | Modbus |
Explains the function of each button and LED on the CFW09 control keypad for user interaction.
Interprets display messages indicating inverter status, faults, and parameter values.
Step-by-step guide for connecting power and motor leads to the CFW09 inverter.
Guides initial parameter programming for proper inverter and motor operation.
How to start, stop, change speed, and jog the motor using the keypad in Local Mode.
Configures inverter for Local or Remote operation using parameter P220 and external switches.
Wiring and parameter settings for 2-wire start/stop control in Remote Mode.
Parameter settings and wiring for 3-wire start/stop control with momentary push buttons.
Connects and configures an analog input for remote speed control using a potentiometer.
Resets the inverter after faults and provides guidance on interpreting fault codes.
Illustrates typical parameter changes for motor and inverter data setup at 60Hz.
Lists parameters for inverter operation modes, speed reference, and FWD/REV selection.
Details read-only parameters for monitoring drive status, inputs, outputs, and fault history.
To Next Page
