Need help?Do you have a question about the WEG DeviceNet CFW500 and is the answer not in the manual?
General| Category | DC Drives |
|---|---|
| DeviceNet | Yes |
| Model | CFW500 |
| Communication Protocol | DeviceNet, Modbus RTU, CANopen |
| Control Type | Vector Control, Scalar Control |
| Protection Features | Overcurrent, Overvoltage, Undervoltage, Overtemperature, Short Circuit |
| Input Voltage | 200-240 V, 380-480 V |
Defines common acronyms and terms used in DeviceNet communication.
Explains how decimal and hexadecimal numbers are represented.
Lists specifications and documents related to DeviceNet protocol development.
Explains CAN as the basis for DeviceNet communication, covering frames and error control.
Details DeviceNet's origins, features, address limits, and communication modes.
Describes DeviceNet's physical characteristics like topology, power, and cabling.
Details the CFW500-CCAN module, its features, and specifications for DeviceNet.
Illustrates the 5-wire plug-in connector pinout for the CAN interface.
Specifies the external power supply requirements for the CAN interface.
Explains how alarms and status are indicated via HMI and parameters.
Provides step-by-step instructions for configuring the DeviceNet module.
Describes how to access device parameters via explicit messages through the network.
Details supported baud rates and their relation to cable length as per ODVA.
Explains the MAC ID addressing scheme and its uniqueness requirement.
Specifies the required termination resistor values to prevent line reflections.
Describes recommended cable characteristics for DeviceNet connections.
Provides guidelines for connecting nodes and managing electromagnetic interference.
Defines symbols (RO, CFG, CAN) used to describe parameter properties.
To Next Page
