Need help?Do you have a question about the WEG Easy Drive CFW10 and is the answer not in the manual?
General| Output Voltage | 0 to Power Supply Voltage |
|---|---|
| Protection Degree | IP20 |
| Communication | RS485 (Modbus RTU) |
| Power Supply Voltage | 200-240 V |
| Power Range | 0.25 to 2 HP |
| Control Type | V/f Control |
| Frequency Range | 0 to 400 Hz |
| Overload Capacity | 150% for 60 seconds |
| Ambient Temperature | -10 to 50°C |
| Cooling Method | Natural convection |
Connects incoming power leads to terminal and grounds the drive and motor, and connects motor leads.
Explains how to start and stop the drive using the keypad in local mode for the first time.
Describes the function of LEDs, buttons, and display elements on the keypad for operation.
Details how to navigate, view, and change parameter values using the keypad.
Further instructions for local mode operation and returning to step 1 for starting the drive.
Explains how to set up and wire for 2-wire start/stop control in remote mode.
Details wiring and parameter settings for 3-wire start/stop control in remote mode.
Explains how faults are displayed and how to reset the drive after a fault occurs.
Lists common parameter changes needed for drive setup and operation.
Discusses parameters for mode selection and monitoring drive values.
To Next Page
