Wega LB 4100 - PROGRAMMING; PROGRAMMING COFFEE DOSES LEFT GROUP; PROGRAMMING COFFEE DOSES RIGHT GROUP

28
espresso coffee machine - user instructions
English
8. PROGRAMMING
Programming must be performed by technical staff.
8.1 PROGRAMMING COFFEE DOSES LEFT GROUP
• hold the continuous button (1) down for at least 5 seconds (the LEDs
of the selections the left group to be programmed will come on);
• insert a pod in the filter holder and attach it to the left group, tightening firmly;
• place the coffee cup under the dispensing spout;
• press the desired dose button (2) (the LED of the dose being
programmed will come on);
• upon reaching the desired serving, confirm by pressing the button (2)
again (the LED of the programmed dose will remain off, while the LEDs of the
buttons yet to be programmed will remain lit);
• repeat this operation for the other dose buttons;
•
repeat the programming for the selections on the other side of the push-button panel.
8.2 PROGRAMMING COFFEE DOSES RIGHT GROUP
• hold the continuous button (1) down for at least 5 seconds (the LEDs
of the selections the right group to be programmed will come on);
• insert a pod in the filter holder and attach it to the right group, tightening firmly;
• place the coffee cup under the dispensing spout;
• press the desired dose button (2) (the LED of the dose being
programmed will come on);
• upon reaching the desired serving, confirm by pressing the button (2)
again (the LED of the programmed dose will remain off, while the LEDs of the
buttons yet to be programmed will remain lit);
• repeat this operation for the other dose buttons;
•
repeat the programming for the selections on the other side of the push-button panel.
0
bar
0,5
1
1,5
2
2,5
61
72
8
9
3
4
10 5
LEFT
GROUP
RIGHT
GROUP
The programming of each dose must be done with a new pod and not with previously used pods.
To exit the programming mode, just wait 30 seconds without performing any operations on the
push-button panel.