Wega LB 4100 - Loading Default Data

English
29
espresso coffee machine - user instructions
8.3 PROGRAMMING HOT WATER DOSES
• hold the button (1) down the right side of the push-button for at least 5 seconds (the LEDs of the selections to be
programmed will come on);
• place the cup under the hot water dispensing nozzle;
• press the hot water button (2) and all the dose button LEDs will come on;
• upon reaching the desired serving, confirm by pressing the button (2) again;
• to exit the programming mode, just wait 30 seconds without performing any operations on the push-button panel.
0
bar
0
,5
1
1,5
2
2,5
3
Acqua calda
0
bar
0
,5
1
1,5
2
2,5
2
3
4
8.4 LOADING DEFAULT DATA
To restore the factory settings, press the buttons (2) (3) (4) simultaneously for 5 seconds
at the start-up of the machine.